Table of Contents
Advertisement
3. S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A 575W HMI lamp is included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
Lamp Installation
1)
Remove the four cover screws as indicated in
figure A. Note that this is the side of the cover
with the fan showing.
2)
Remove the two thumbscre
figure B.
3)
Lift the fan to
indicated in figure B.
4)
Pull the reflector housing to
the had as indicated in figure C.
5)
Remove the two lamp screws indicated in
figure D.
6)
Remove the lam
Warning:
Nipple on lamp mus
or directly down with respect to the head.
In other words, the nipple should NOT be
pointing towards the back of the reflector,
or towards the front of the head. Damage
to the reflector can occur if these
instructions are not followed!
7)
Hold the new lamp with a lint-free
insert into lamp socket, making sure that the
nipple on the lamp is pointing up or down, and
not towards the reflector or front.
8)
Tighten lamp screws.
9)
Gently push reflector to
head.
10)
Lower fa
thumbscrews.
11)
Replace top cover.
Q-Wash 575 User Manual
ws indicated in
wards the back of the head as
wards the back of
p.
t be facing directly up
cloth and
wards the front of the
n towards lamp and tighten the two
7
Figure A
Figure B
Figure C
Figure D
8/3/2007 9:10:00 AM
Advertisement
Table of Contents
