Setup; Ac Power; Lamp Installation - Chauvet Intimidator Spot DMX-680 User Manual

3. Setup

AC Power

Warning! Verify that the power requirement label on your unit matches the line voltage
applied. All fixtures must be connected to circuits with a suitable Earth Ground.
• To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart.
• A fixture's listed current rating is its average current draw under normal conditions.
• All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
• Before applying power to a fixture, check that the source voltage matches the fixture's
requirement.
• All fixtures must be connected to circuits with a suitable Earth Ground.
P ow e r C a b l e C o n f i g u r a t i o n
C
ABLE
B
ROWN
B
Y
ELLOW

Lamp Installation

You will need to install a lamp prior to the initial operation of the fixture.
Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
L a m p I n s t a l l a t i o n
1. Remove screws labeled (S1) and pull out lamp
socket plate.
2. If replacing the lamp, remove old lamp first.
3. Release the retaining clips as shown on figure 1.
Both the lamp along with the socket will be
released.
4. Detach the lamp from the socket and replace the
lamp.
5. Place the lamp back into the lamp cage and secure
the clips back in place.
6. There is no lamp alignment since the lamp is already
optimized inside a mirrored dichroic reflector.
7. Insert lamp socket plate back into the rear of the fixture and tighten
screws to complete installation.
DMX-680 User Manual
Pin International
Live
Neutral
LUE
/G Earth EG (Ground)
REEN
Screw Color
L Yellow or Brass
N Silver
Green
S1
7
1
2006-10-10 18:04
/