Table of Contents
Advertisement
S
ETUP
LAMP
M axim iz in g t h e li f e o f you r l a mp
To ensure the longest and most efficient use of the lamp always wait
between 10 and 15 minutes before re-applying power after a shutdown.
Failure to do so could result in premature aging of the lamp and failure to
the electronics that drive it.
You will need to install a lamp prior to the initial operation of the fixture. A HMI575 high intensity
discharge lamp is included. Do not touch the envelope (glass area) of the bulb with bare hands. If this
happens, clean the lamp with alcohol and wipe it with a lint free cloth before installation.
Lam p In st a ll at ion
1. Unscrew (S1) to detach the top cover.
2. Unscrew (S2) to remove
lamp cover and expose
lamp compartment.
3. If installing a new lamp,
loosen both screws on
the double ended lamp
to allow for the lamp to
slide into the lamp
socket slots. Lower lamp evenly.
4. If replacing a lamp, loosen both lamp
screws (S3) to relieve tension from
lamp socket slots so you can slide the
lamp freely, upwards and out of lamp
socket. Raise lamp evenly to remove.
5. Before you tighten the lamp end screws, rotate the
bulb until the nipple on the envelope (N) of the bulb is
facing upwards as illustrated.
6. DO NOT OPERATE UNIT WITHOUT LAMP AND
FIXTURE COVERS SECURELY REPLACED!
Q-Spot 575 User Manual
1
Please use a flat-head screw
driver to loosen and tighten
(S2) thumbscrews securely!
Always
replace Lamp
cover and Top
cover before
re-igniting
lamp!
3,4
5
N
6
S1
1
S2
2
2
S3
2006-05-17/13:25
Hide quick links:
Advertisement
Table of Contents
