Table of Contents
Advertisement
3. S
ETUP
Lamp
You will need to install a lamp prior to the initial operation of the fixture. A 250W lamp is included.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint free cloth before installation.
Lamp Installation
1)
Unscrew the two thumbscrews (Figure
A).
2)
Hold the lamp removal knob and pull
the lamp housing directly out (Figure
B).
3)
Slide the lamp up past the spring clips
to remove it. (Figure 3).
4)
Remove the lamp from the socket
(Figure C)
5)
Hold the new lamp with a lint-free c
Insert lamp into socket.
6)
Slide the lamp down past the springs
until it stops.
7)
Insert lamp housing into the fixture.
8)
Tighten both thumbscrews
SX Abyss User Manual
Figure A
loth.
Figure B
Figure C
6
2006-12-11/15:07
Advertisement
Table of Contents
