CyberData 011182 Operation Manual page 43

3. On the Home Page, review the setup details described in
Web Page Item
Device Settings
Change Username
Change Password
Re-enter Password
Current Settings
Serial Number
Mac Address
Firmware Version
IP Addressing
IP Address
Subnet Mask
DNS Server 1
DNS Server 2
Boot Time
Current Time
I C Servers
Configuration File
B'casts Accepted
B'casts Rejected
B'casts Active
RTP Packets Rx'd
Clock Status
Clock Firmware
Beep on Initialization
Button Lit When Idle
Blink Button While Recording
Activate Relay While Recording
Operations Guide
Table 2-5. Home Page Overview
Description
Type in this field to change the username (25 character limit).
Type in this field to change the password (19 character limit).
Type the password again in this field to confirm the new password
(19 character limit).
Shows the device serial number.
Shows the device Mac address.
Shows the current firmware version.
Shows the current IP addressing setting (DHCP or Static).
Shows the current IP address.
Shows the current subnet mask address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Shows the boot time.
Shows the current time.
Shows the InformaCast Server IP addresses.
Shows the configuration file.
Shows the number of B'casts accepted.
Shows the number of B'casts rejected.
Shows the number of active B'casts.
Shows the number of RTP packets Rx'd.
Shows the current clock status.
Shows the current clock firmware version.
When Yes is selected, you will hear a beep when the device
initializes.
When selected, the Remote Call Button LED remains lit when idle.
When selected, the Remote Call Button LED blinks while a call is in
progress.
When selected, the relay will activate while a call is in progress.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930463C
Installing the Singlewire-enabled Speaker
Configure the Speaker Parameters
Table 2-5.
CyberData Corporation
36