Talkback And Oscillator Controls - SoundCraft Vi3000 User Manual

® ®
Talkback And
Oscillator Set-
up
Open and close the
Talkback and Oscil-
lator setup screen in
the master Vistonics
screen.
Talkback XLR
Connector
One of two parallel
Talkback Mic inputs.
Talkback / OSC
Level Control
Control of Talkback or
Oscillator level.
Talkback To
Internal
Route the Talkback
signal to pre-selected
output busses.
4.3 15.1
Vi3000 USER MANUAL Vi3000 USER MANUAL

15.1: Talkback And Oscillator Controls

There is also a Talkback Mic XLR input on the rear of the
console. The switch for phantom power for both sockets,
if it is required, is next to the rear panel socket.
For Talkback, the base analogue Mic Amp gain is set at
one of three values (46dB, 56dB, or 66dB) by an internal
jumper located on the pcb that holds the rear panel
Talkback mic socket. If the Oscillator is active, the control
adjusts the Osc level to all destinations. The level setting
is stored independently for TB and Osc.
The 'INT' routed Output busses are selected via their
{TB} VST keys in the VST area of the master screen
after selecting the [TB ASSN] key (located to the right of
the master screen's VST area). Switch between the two
sets of 16 busses with the [PAGE A] and [PAGE B] keys.
15.1 TALKBACK & OSC > CONTROLS 4.3: INPUT CHANNEL > DYNAMICS
15.1 TALKBACK & OSC > CONTROLS INPUT CHANNEL > De Esser
Active
Open Setup
Screen