Midplane Board; Removing The Midplane - QUANTA Rackgo X Series F03A Technical Manual

I H
NSTALLING ARDWARE

2.5 Midplane board

The midplane board serves as a bridge between the power system and the nodes.
CAUTION!
!
E
NSURE ALL POWER IS DISCONNECTED FROM THE SYSTEM BEFORE PROCEEDING

Removing the Midplane

1. Power off the sled tray by sliding the sled tray out of the chassis. See Releasing the
Sled Tray on page 2-2.
2. Place the sled tray on a clean work surface.
3. Remove the enclosure from the rack. Place the enclosure on a clean work surface.
4. Remove the rear assembly.
Figure 2-16. Removing rear assembly
M
IDPLANE BOARD
.
2-12