Cooling And Airflow; Laser Peripherals Or Devices - QUANTA Rackgo X Series F03A Technical Manual

Electrostatic Discharge (ESD)
CAUTION!
!
ESD
CAN DAMAGE DRIVES
ESD
AT AN WORKSTATION
STATIC WRIST STRAP ATTACHED TO CHASSIS GROUND
WHEN HANDLING PARTS
Always handle boards carefully. They can be extremely sensitive to ESD. Hold boards only
by their edges without any component and pin touching. After removing a board from its
protective wrapper or from the system, place the board component side up on a
grounded, static free surface. Use a conductive foam pad if available but not the board
wrapper. Do not slide board over any surface.

Cooling and Airflow

CAUTION!
!
C
AREFULLY ROUTE CABLES AS DIRECTED TO MINIMIZE AIRFLOW BLOCKAGE AND COOLING PROBLEMS
PROPER COOLING AND AIRFLOW
. O
INSTALLED
T
O INSTALL THE COVERS
 Check first to make sure you have not left loose tools or parts inside the system.
 Check that cables, add-in cards, and other components are properly installed.
Attach the covers* / air duct* to the chassis according to the product instructions.
* May not apply to all systems.
Please be aware that slots and openings on the front and rear side of the chassis are
designed for ventilation; to make sure reliable operation of your system and to protect it
from overheating, these openings must not be covered or blocked. The openings should
never be covered or blocked by placing the product on a bed, sofa, rug, or other similar
surface. This product should never be placed near or over a radiator or heat register, or in a
built-in installation unless proper ventilation is provided.

Laser Peripherals or Devices

CAUTION!
!
T
O AVOID RISK OF RADIATION EXPOSURE AND

Do not open the enclosure of any laser peripheral or device.
 Laser peripherals or devices are not serviceable.
 Return to manufacturer for servicing.
Use certified and rated Laser Class I for Optical Transceiver product.
Heed safety instructions: Before working with the system, whether using this manual or
any other resource as a reference, pay close attention to the safety instructions. Adhere to
the assembly instructions in this manual to ensure and maintain compliance with existing
product certifications and approvals. Use only the described, regulated components spec-
, ,
BOARDS AND OTHER PARTS
. I
F ONE IS NOT AVAILABLE
.
,
OPERATE THE SYSTEM ONLY WITH THE CHASSIS COVERS
PERATING THE SYSTEM WITHOUT THE COVERS
* / *:
AIR DUCT
. W
E RECOMMEND THAT YOU PERFORM ALL PROCEDURES
, ESD
PROVIDE SOME
--
ANY UNPAINTED METAL SURFACE
/ *
AIR DUCT IN PLACE CAN DAMAGE SYSTEM PARTS
/ :
OR PERSONAL INJURY
P M
RECAUTIONARY
PROTECTION BY WEARING AN ANTI
--
ON YOUR SERVER
. F
OR
* / *
AIR DUCT
EASURES
-
.
XIV