Table of Contents
Advertisement
3.11 Hard Disk Test
To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TEST menu, press Enter
and follow the directions displayed on the screen. The Hard Disk Test contains 10 subtests
that test the functions of the hard disk.
NOTE: The contents of the hard disk will be erased when Subtest 02, 03, 04, 05, 06,
08, 09, or 10 is executed. Before running the test, transfer the contents of the hard
disk to floppy disk.
If MS-DOS 6.22 and Windows for Workgroups is selected, use the Master Diskette
Creator (MDC) utility in the Toshiba Utility folder.
If Windows 95 is selected, use the Microsoft Create System Disks Tools (MSCSD.EXE)
in the System Tools Folder.
For more information, refer to the appropriate instructions for each operating system.
The following messages will appear after selecting the Hard Disk Test. Answer each of the
following questions with an appropriate response to execute the test:
1.
When you select the Hard Disk Test from the DIAGNOSTIC TEST menu, the
following message will appear:
Test drive number select (1:HDD#1,2:HDD#2,0:HDD1&2) ?
2.
Select the hard disk drive number to be tested and press Enter. The following
message will appear:
HDC F/W error retry
This message is used to select the retry operation when the hard disk controller
detects an error.
3.
Select 1 or 2 and press Enter. The following message will appear:
Data compare error dump (1:no,2:yes) ?
This message is used to select the error dump operation when a data compare
error is detected.
3-24
(1:yes,2:no) ?
650CT
Advertisement
Table of Contents
Troubleshooting
