Table of Contents
Advertisement
(c)
Remove the Diagnostics Disk from the FDD, insert the source disk, and
press any key. The following message will appear, indicating the program
has started.
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = XX
Copy start
(d)
Remove the source disk from the FDD, insert a formatted work disk, and
press any key. The [[ track, head = XXX X ]] message will appear and
start copying to the target disk. When the amount of data is too large to be
copied in one operation, the message from step (b) is displayed again. After
the floppy disk has been copied, the following message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(e)
To copy another disk, type 1 and the message from step (a) will be displayed
again. Entering 2 returns the test program to the DIAGNOSTIC MENU.
4.
DUMP program
(a)
When DUMP is selected, the following message appears:
DIAGNOSTICS-HARD
Drive type select (1:FDD, 2:HDD) ?
(b)
Select a drive type. If 1 is selected in step (a), the following message dis-
plays:
Select drive number (1:A, 2:B) ?
Select an FDD drive number. The display will go to step (c).
If 2 is selected, the following message displays:
Select drive number (1:C, 2:D) ?
After selecting the HDD, the display will go to step (f).
(c)
The following message will be displayed:
Format type select (1:2DD, 2:2D, 3:2HD) ?
(d)
Select a format type. The following message displays:
Insert source disk into drive A:
Press any key when ready.
3-50
= XXX
= X
[[ track,head
=
DISK & FLOPPY DISK DUMP : VX.XX
XXX X ]]
650CT
Advertisement
Table of Contents
Troubleshooting
