Table of Contents
Advertisement
Installing the FL Inverter Board
To install the FL inverter board, follow the steps below and refer to Figure 4-36.
1.
Connect the FL inverter cable to CN2 and the FL cable to CN1 and lay the FL
inverter board in place.
2.
Secure the FL inverter board with two M2x6 screws.
NOTE: Support the display with your hand, book, or support block when you
insert the screws.
3.
Install the display mask, optional PC card, optional memory module, and battery
pack as described in Sections 4.14, 4.4, 4.3, and 4.2.
650CT
4-37
Advertisement
Table of Contents
Troubleshooting
