Table of Contents
Advertisement
Installing the Speaker
To install the speaker, follow the steps below and refer to Figures 4-30 back through 4-27.
1.
Connect the speaker cable to PJ504 on the system board.
2.
Seat the speaker in the speaker case, then seat the assembly in the speaker module.
3.
Seat the speaker module in the computer.
4.
Secure the speaker module with two M2x6 screws (the left screw secures the
ground cable).
5.
Seat the modem base and secure it with one M2x6 screw.
6.
Seat the I/O board base and secure it with one M2x6 screw.
7.
Install the RTC battery and I/O board and PC card slot, membrane switch and
backup battery, top cover with display assembly, keyboard, DAA module, HDD,
optional PC card, optional memory module and battery pack as described in
Sections 4.10 back through 4.2.
4-30
650CT
Advertisement
Table of Contents
Troubleshooting
