Table of Contents
Advertisement
Quick Charge Check
The power supply may not be charging the battery pack. Perform the following procedures:
1.
Reinstall the battery pack.
2.
Attach the AC adapter and turn on the power. If you cannot turn on the power, go
to Procedure 5.
3.
Run the Diagnostic test, then go to the System test and execute subtest 06 (Quick
Charge) described in Chapter 3.
4.
When the quick charge is completed, the diagnostics test displays the result code.
Check the code against the table below and perform any necessary check(s).
Result code
0
1
2
3
4
5
6
7
8
Check 1
Make sure the AC adapter's cable and AC power cord are firmly plugged into the
DC IN socket and wall outlet. If these cables are connected correctly, replace the
AC power cord and AC adapter.
Check 2
Make sure the battery is properly installed. If it is, replace it with a new battery.
Check 3
See if the battery pack is completely discharged. Wait a few minutes to charge it.
If the battery pack still isn't charged, replace it with a new one.
Check 4
The battery's temperature is hot or cold. Return the battery to a normal opera-
tional condition. If the battery pack still doesn't charge, replace it with a new one.
Check 5
Go to Procedure 5.
2-12
Contents
The battery is quick charging normally.
The battery is fully charged.
The AC adapter is not attached.
The AC adapter's output voltage is not normal.
No battery is installed.
The battery's output voltage is not normal.
The battery's temperature is not normal.
A bad battery is installed.
Any other problems.
Check items
Normal
Normal
Check 1
Check 1
Check 2
Check 3
Check 4
Check 2
Check 5
650CT
Advertisement
Table of Contents
Troubleshooting
