Table of Contents
Advertisement
Installing the DAA Module
To install the DAA module, follow the steps below and refer to Figures 4-16 back through
4-13.
1.
Seat the DAA board into the bottom cover and secure the latches.
2.
Seat the upper cover and secure the latches.
3.
Seat the metal plate and secure it with two M2.5x4 screws. Pull the bottom cover
up to place the metal plate over the guide pin.
4.
Insert the DAA module into the computer and press gently to secure the
connection.
5.
Secure the DAA module with two M2x6 screws.
6.
Replace the cover starting with the bottom right.
7.
Install the battery pack as described in Section 4.2.
650CT
4-17
Advertisement
Table of Contents
Troubleshooting
