Top-Of-Form Setting - IBM Personal Computer AT Manual To Operations

Top-of-Form Setting
1
Be sure your printer's power is off.
2
Raise your printer access cover.
3
U sing the roller knob, roll the paper up so that
the perforation line is to the top of the print
scale.
4
Lower the printer access cover.
5
Turn your printer's power on.
6
To change the top-of-form setting, repeat the
above sequence.
Note: The position of the paper when the printer's
power is turned on determines where the paper will
feed to when a Form Feed command is given. For
example, if the print scale is in the middle of the
form when the power is turned on, the paper feeds
to the middle of the next page when the Form Feed
command is given or when the Form Feed button is
pressed. The length of the page can be changed by
using printer commands from your system unit.
When your printer's power is turned off and then on
again or when your printer receives a printer reset
from the system unit, the page length is 279.4 mm
(11
in.).
Graphics Printer 1-17