Table of Contents
Advertisement
Test Mode Button and Test Mode Light
26
Press the Test Mode button until the Test Mode
light is on. Your printer is now in the test mode.
After three seconds, your printer starts printing a
~
pattern of all of the printable characters. The ribbon
color changes every 25.4 mm
(1
in.). This is the
printer self-test.
27
Press the Test Mode button again to stop the
test. The Test Mode light goes out to show your
printer is no longer in the test mode.
Note: You will probably want to set the DIP
switches to a setting other than the printer self-test
setup. When you finish this installation, refer to
"DIP Switch Settings" for all of the available
settings.
1- 72 Color Printer
Advertisement
Table of Contents
