Configuring Cos Settings - Cisco RV180 Administrator's Manual

Configuring Quality of Service (QoS)

Configuring CoS Settings

STEP 4
STEP 5
STEP 6
Configuring CoS Settings
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide
If the service you are looking for is not in the drop-down menu, you can configure a
custom service in the Firewall page (see
From the Traffic Selector Match Type drop-down menu, choose the traffic selector
to use to bind traffic to the profile.
Depending on the traffic selector you chose, enter this information:
Starting IP Address
Ending IP Address
MAC Address
VLAN ID
DSCP Value
Available SSIDs
Click Save.
You can map CoS priority settings to the traffic forwarding queue on the RV180/
RV180W.
To map CoS priority settings to the traffic forwarding queue:
Choose QoS > CoS Settings > Cos Settings.
In the CoS to Queue field, check Enable.
For each CoS priority level in the CoS to Traffic Forwarding Queue Mapping
Table, choose a priority value from the Traffic Forwarding Queue drop-down
menu.
Creating Custom Services, page
Enter the starting IP address of the range.
Enter the ending IP address of the range.
Enter the MAC address for any client device (for
example, a PC or wireless client) to which you want
to assign the bandwidth.
Choose the VLAN ID on the router to which the
traffic selector applies.
Enter the Differentiated Services Code Point
(DSCP) value (0–63).
This value determines how the traffic is prioritized.
Choose the SSID the selector applies to from the
drop-down menu.
6
95.)
131