Configuring Profile Binding; Adding A Profile Binding - Cisco RV180 Administrator's Manual

Configuring Quality of Service (QoS)

Configuring Profile Binding

STEP 3
STEP 4
STEP 5
Configuring Profile Binding
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide
Enter this information:
Name
Priority
Minimum Bandwidth
Rate
Maximum Bandwidth
Rate
Click Save.
To bind the profile to a traffic selector, see
After creating WAN QoS profiles, you must bind them to traffic selectors. The
Profile Binding Table displays the profiles you have added, along with the service
to which the profile applies, the traffic selector match type (IP address range, MAC
address, VLAN, DSCP, or SSID), and the profile to which the binding is matched (in
the "match configuration" field).

Adding a Profile Binding

To create a profile binding:
Choose QoS > Profile Binding.
In the Available Profiles field, choose a WAN QoS profile.
To create a profile, click Configure Profile. See
page 128 for more information.
From the Service drop-down menu, choose the service to which the profile
applies.
Enter the name of the profile.
If the WAN QoS mode is set to Priority, choose the
priority level from the drop-down menu.
If the WAN QoS mode is set to Rate Limit, enter the
minimum bandwidth rate (1 to total WAN
bandwidth in Kbps).
If the WAN QoS mode is set to Rate Limit, enter the
maximum bandwidth rate (100–1000000 Kbps).
Configuring Profile Binding, page
Configuring WAN QoS Profiles,
6
130.
130