Configuring Static Ip; Configuring Pppoe - Cisco RV180 Administrator's Manual

Configuring Networking
Configuring the WAN (Internet) Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
Cisco RV180/RV180W Administration Guide

Configuring Static IP

If your ISP assigned you a permanent IP address, perform the following steps to
configure your WAN settings:
Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
From the Internet Connection Type drop-down menu, choose Static IP.
Enter this information:
IP Address
Subnet mask
Default Gateway
Primary DNS Server
Secondary DNS Server
Enter MTU information. (See
Enter MAC Address information. (See
Click Save.

Configuring PPPoE

If you have a Point-to-Point Protocol over Ethernet (PPPoE) connection to the
Internet:
Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
From the Internet Connection Type drop-down menu, choose PPPoE.
From the PPPoE Profile Name drop-down menu, choose a PPPoE profile. If no
profile is listed, click Configure Profile to create a new profile.
Enter the IP address that your ISP has assigned to
you.
Enter subnet mask that your ISP has assigned to
you.
Enter the IP address of the IPS's gateway.
Enter the IP address of the primary DNS server
used by your ISP.
(Optional) Enter the IP address of the secondary
DNS server. This is used if the primary DNS server
fails.
Configuring MTU Settings, page
Configuring the MAC Address, page
2
29.)
29.)
26