MUTOH VJ-2638 Installation Manual page 13

41 Attach the right roll media holder to the
roll media and tighten the fixing lever.
No1 Name No1
1 Roll media holder (Right) 3 Fixing lever
2 Roll media
● When tightening Fixing lever, press Roll
media holder toward the printer. If you do not
press Roll media holder, Fixing lever may not
be completely locked because of the weight
of the roll media.
51 Loosen the fixing levers of the right and
left roll media holders, slide the roll media
to the center and tighten the levers.
No1 Name No1
1 Roll media holder (Left) 3 Roll media
2 Roll media holder (Right) 4 Fixing levers
61
Turn the printer ON.
• The printer starts initial operation.
• "Media End" is displayed on the operation
panel.
71
Raise the media loading lever.
No1 Name
1 Media loading lever
• "Lever Up" is displayed on the operation
panel.
81 Open the front cover.
No1 Name
1 Front cover
91 Insert the roll media into the media feed
slot.
Name
No1 Name
1 Roll media
111 Pull the roll media approximately 1 m out
of the media feed slot, which is inside the
front cover.
No1 Name
1 Roll media
111 While holding the front end of the roll
media, wind the media back for a short
distance by turning the flanges of the roll
media holders so that the media is not
slack or slanted.
Name
● This procedure must be done by 2 or more
persons.
●
If you release your grip on the roll media
while it is being wound, the media may slip
off the media feed slot and fall behind the
printer.
● Make sure that the right end of the roll media
does not go beyond the media loading mark.
It may affect print quality.
No1 Name
1 Roll media
No1 Name
1 Roll media
VJ-2638/1638/1638W Installation Manual
111
•
No1 Name
2 Media feed slot
No1
<VJ-2638/1638>
No1 Name
2 Media feed slot
No1
<VJ-1638W>
No1
●
No1 Name
2 Roll media holder
No1 Name
No1
2 Media loading mark
13
Make sure that the edges of the media
is appropriately pressed by Pressurizing
rollers.
When the media is set as shown in the
following figure X, follow the procedure on a
and b below to adjust the position of the roll
media. If the media looked like in the figure X,
media may slant or wrinkle may be occured
when printing.
Name No1
1 Roll media 2 Pressurizing roller
Name No1
1 Roll media 2 Pressurizing roller
Name No1
1 Roll media 2 Pressurizing roller
a1
Loosen the fixing levers of the right and
left roll media holders, and move the roll
media to the right or left.
b1 After moving the roll media, tighten the
fixing levers.
When tightening Fixing lever, press Roll
media holder toward the printer. If you do not
press Roll media holder, Fixing lever may not
be completely locked because of the weight
of the roll media.
Name No1
1 Roll media holder (Left) 3 Roll media
2 Roll media holder (Right) 4 Fixing levers
VJ1638xE-I-03
Name
Name
Name
Name