General Specifications - Hellenbrand ProMate Series Owner's Manual

Noting the one possible orientation of the transfer drive cap, use
one hand to press in and support the transfer drive cap while
using the opposing hand to start two screws in, one on the top
and one opposing it on the bottom. Tighten the screws in evenly
so the cap seats the O-ring without getting pinched or damaged.
Screws should only be hand tightened with a 5/32" or 4mm allen
wrench, DO NOT OVER TIGHTEN SCREWS.
NOTE: be careful and make sure the meter cable doesn't get
under the drive cap while tightening as it will result in damaging
the cable.
Position the large white drive gear with the "A" pointing toward
the 1 o'clock position and then press it onto the stainless steel
drive shaft, make sure it snaps & locks into position. NOTE:
The white drive gear is splined to the drive shaft and will only
assemble in one orientation. Because of this it is not necessary
that the discs and gear be exactly positioned, the positioning
needs to be approximate but they have to fit on the shaft.
Next install the larger black reducing gear onto the stainless steel
shaft, then install the remaining smaller reducing gears from left
to right. Re-install the grey reducing gear cover over the gears
and affix with the 3
stainless steel screws. Now you can re-install the drive motor by
pressing the spring clip loop to the right then rotate the motor
as you are inserting it so the gear of the motor meshes properly
with the reducing gears. Release the spring clip loop and rotate
the motor untill the motor housing engages with the plastic nub
inside the housing that holds the motor in place and make sure
that the top of the motor is flush with the top of the grey gear
housing. Press the drive motor wires down into the strain relief of
the drive cap, now you can
re-install the cover assembly.
OPERATING PRESSURES
Minimum/Maximum ..................................................................................................................................25 psi-125 psi
OPERATING TEMPERATURES
Minimum/Maximum ..................................................................................................................................40º - 110º F
METER
Accuracy ...................................................................................................................................................±5%
Flow Rate Range......................................................................................................................................0.25 - 27 GPM
Gallon Range ...........................................................................................................................................20 - 1,500,000
DIMENSIONS
Drain Line .................................................................................................................................................3/4" or 1" NPT
Brine Line .................................................................................................................................................3/8" Poly Tube
ELECTRICAL CURRENT DRAW/VOLTAGE/FREQUENCY ...................................................................................0.5A/110v/60Hz
TANK THREAD .......................................................................................................................................................2-1/2" - 8 NPSM
Compatible with the following regenerants or chemicals: Sodium chloride, potassium permanganate, sodium bisulfite, sodium hydroxide,
hydroxide, hydrochloric acid, chlorine and chloramines.
35

GenerAl SPeCifiCATiOnS

After completing any valve maintenance involving the valve
drive assembly or the transfer drive assembly please press and
hold the NEXT & the REGEN buttons simultaneously for 3 to
5 seconds to perform a soft reset which will synchronize the
control valves positions.
"A" text orientated
towards 1 o'clock
Splines can only
fit one direction
on shaft.