Seat Location Post (3300 Ce Only) - Stairmaster Stratus Systems Owner's Manual

PARTS REMOVAL AND REPLACEMENT

SEAT LOCATION POST (3300 CE ONLY)

1. Pull the seat adjustment knob out and raise the seat.
2. Insert a phillips screwdriver into one of the holes in the seat post that
are visible above the seat tube cap (see Figure 18). Gently lower the
seat so that the seat is held up by the screwdriver.
3. Hold the seat adjustment shaft with a pair of locking pliers and
remove the seat adjustment knob from the shaft by turning the knob
counterclockwise.
4. Remove the screwdriver from the hole in the seat post and lower
the seat slightly so the seat adjustment shaft engages a hole in the
seat post.
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE
5. Remove the internal snap ring that is now visible inside the seat
knob housing.
6. Lift the seat slightly and pull out the seat adjustment shaft. Remove
both washers and the spring from inside the seat knob housing.
7. Insert a phillips screwdriver into one of the holes in the seat post that
are visible above the seat tube cap and remove the internal snap
ring located in front of the seat adjustment bushing inside the seat
knob housing.
8. Remove the two screws securing the seat tube cap to the frame.
9. Remove the screwdriver from the seat post. Raise the seat tube cap
up and away from the frame.
Page 44
!
WARNING
PROTECTION WHEN REMOVING SNAP RINGS.