Table of Contents
Advertisement
PARTS REMOVAL AND REPLACEMENT
SEAT
3300 CE
1.
Loosen and remove the four mounting nuts and lock washers located
underneath the seat (see Figure 18).
2.
Remove the seat. Reverse the steps to reinstall.
3900 RC
The seat pads can be removed while the seat is in the seat track. Loosen and
remove the four mounting bolts from each seat pad and lift the pad free. To
remove the seat from the seat track:
1.
Loosen and remove the nyloc nut and flat washer from the rear of the
seat track. Remove the bolt (see Figure 17).
2.
Remove the seat track cover.
3.
Lift the seat adjustment handle and slide the seat to the rear and off
the track.
4.
To reinstall the seat, line up the front guide wheels with the seat
track. Carefully slide the seat forward while holding up on the seat
adjustment handle until all six wheels are in the seat track.
5.
Verify proper operation of the seat adjustment handle before
installing the seat track cover.
6.
Install the bolt through the seat track and track cover. Install and
securely tighten the flat washer and the nyloc nut.
7.
The seat track play can be adjusted by loosening the nut on both
center wheels while using a standard screwdriver to turn the bolt.
Ideally, the seat should slide easily without excessive side play.
Tighten the nuts after the wheels are adjusted (see Figure 19).
Page 43
Advertisement
Table of Contents
Troubleshooting
