WARNING:
internal system components to cool before touching them.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 25).
4.
If installed, remove the PCI air baffle (on page 27).
5.
Remove the system air baffle (on page 28).
6.
Disconnect all power supply cables from the system board, drive cages, and devices.
7.
Remove the non-hot-plug power supply.
8.
To replace the component, reverse the removal procedure.
RPS enablement kit
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, take the appropriate anti-static
Removal and replacement procedures 62