Hot-plug SFF drive blank
o
To replace the SFF drive blank, while pressing the release latch, slide the component into the bay
until it is fully seated.
Hot-plug drive
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
Remove the front bezel (on page 26).
2.
Determine the status of the drive from the drive LED definitions
3.
86).
Remove the hot-plug drive.
4.
To replace the component, reverse the removal procedure.
To prevent improper cooling and thermal damage, do not operate the server unless
("HP SmartDrive LED
definitions" on page
Removal and replacement procedures 31