Hp 750 W Cs -48 V Dc Power Supply Enablement Kit - HP ProLiant DL320e Gen8 v2 Maintenance And Service Manual

Remove the power supply.
7.
To replace the component, reverse the removal procedure.

HP 750 W CS -48 V DC power supply enablement kit

To remove the component:
Power down the server (on page 28).
1.
Remove the power from the server:
2.
Disconnect the power cord from the power source.
a.
Disconnect the power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 29).
o
Remove the server from the rack (on page 30).
o
Remove the access panel
4.
WARNING:
power supply blank to cool before touching it.
Remove the power supply
5.
Disconnect the Mini-SAS cable from the drive cage backplane.
6.
Disconnect all cables from the power distribution board.
7.
("Access panel" on page 35).
To reduce the risk of personal injury from hot surfaces, allow the power supply or
("HP CS power supply" on page 33).
Removal and replacement procedures 62