Heatsink - HP ProLiant ML110 Gen9 Maintenance And Service Manual

Remove the DIMM.
8.
To replace the component, reverse the removal procedure.

Heatsink

To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 25).
4.
If installed, remove the PCI air baffle (on page 27).
5.
Remove the system air baffle (on page 28).
6.
Remove the heatsink:
7.
Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
a.
Completely loosen all screws in the same sequence.
b.
Removal and replacement procedures 44