Processor - HP ProLiant ML110 Gen9 Maintenance And Service Manual

Finish the installation by completely tightening the screws in the same sequence.
c.
Install the system air baffle.
4.
If removed, install the PCI air baffle.
5.
Install the access panel.
6.
Return the server to an upright position.
7.
Connect each power cord to the server.
8.
Connect each power cord to the power source.
9.
Power up the server.
10.

Processor

WARNING:
internal system components to cool before touching them.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
CAUTION:
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
IMPORTANT:
installing the processor.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
To prevent damage to electrical components, take the appropriate anti-static
If installing a processor with a faster speed, update the system ROM before
Removal and replacement procedures 46