HP ProLiant ML110 Gen9 Maintenance And Service Manual page 87

Item LED Status
Flashing green
Flashing
amber/green
Flashing amber
Solid amber
Off
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT: The HP Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode.
It cannot be enabled in Legacy BIOS Boot Mode. If the B140i controller is disabled, drives
connected to the system board Mini-SAS connectors operate in AHCI or Legacy mode. Under this
condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
•
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities
page 72) to enable or disable the B140i controller (System Configuration → BIOS/Platform
Configuration (RBSU) → System Options → SATA Controller Options → Embedded SATA
Configuration).
Definition
The drive is rebuilding or performing a RAID migration, strip size
migration, capacity expansion, or logical drive extension, or is
erasing.
The drive is a member of one or more logical drives and predicts
the drive will fail.
The drive is not configured and predicts the drive will fail.
The drive has failed.
The drive is not configured by a RAID controller.
("HP UEFI System Utilities" on
Component identification 87