8-Bay Sff Hot-Plug Drive Cage - HP ProLiant ML110 Gen9 Maintenance And Service Manual

Box 2
o
To replace the component, reverse the removal procedure.

8-bay SFF hot-plug drive cage

WARNING:
internal system components to cool before touching them.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Place the server on its side.
3.
Remove the access panel (on page 25).
4.
Remove the front bezel (on page 26).
5.
Remove all drives
6.
Remove all drive blanks
7.
If installed, remove the PCI air baffle (on page 27).
8.
Remove the system air baffle (on page 28).
9.
Disconnect the Mini-SAS cable and the power cable from the drive backplane.
10.
Disconnect the hard drive power good cable from the system board. Hard drive power good cable is
11.
attached to the drive cage by default.
Remove the SFF hot-plug drive cage.
12.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
("Hot-plug drive" on page 31).
("Hot-plug drive blanks" on page 30).
Removal and replacement procedures 33