HP 3000 99x Family Installation Manual page 54

Installation
Summary
2. For HP-IB tape devices, connect the tape device to the HP-IB card in slot 3.
(Address 0/12.0.3).
iii. For systems with SCSI system disks:
1. For SCSI tape devices, connect the tape device to the SCSI card in slot 13 of
the internal HP-PB I/O card cage. (Address 0/52.0.0).
2. For HP-IB tape devices, connect the tape device to the HP-IB card in slot 3.
(Address 0/12.0.3).
iii. For systems with Fast/Wide SCSI system disks:
1. For SCSI tape devices, connect the tape device to the SCSI card in slot 9 of the
internal HP-PB I/O card cage. (Address 0/36.0.0).
2. For HP-IB tape devices, connect the tape device to the HP-IB card in slot 3.
(Address 0/12.0.3).
11.Verify system operation.
a. Make sure console, peripherals, expansion cabinets, and external HP-PB card cages
(if any) are powered up and ready.
b. Power up the computer:
i. Turn on the circuit breaker switch at the rear of the SPU cabinet.
ii. Turn the "Standby-Ready" switch on the front panel to the "Ready" position.
c. Enter the PDC user interface.
d. Enter the PDC command to enable or disable the memory page deallocation table
(PDT).
e. Verify that indicators show normal status.
f. Check the SP error log with the DL command (SP)
g. Check the autostart flag with the AF command (SP).
h. Check the PMB card cage configuration with the HC command (SP).
12.Set boot parameters.
a. Enter the PDC boot menu.
b. Verify/change autoboot flag.
c. Verify/change default hardware paths. See PDC on-line help for appropriate values.
13.Operating system.
a. Load the operating system if necessary. Some configurations are preloaded at the
factory.
b. Boot the operating system.
c. If OS patches are included with the system, install them now.
3-6 Chapter 3