Table of Contents
Advertisement
3. Use the LD command to list the current parameters for LDEV 21:
io> LD 21
You will see:
LDEV:
21
DEVNAME:
ID: HPC2204A
PATH: 0/36.0
4. Use the MD command to modify the parameters for LDEV 21:
io> MD 21 id=HP28639-60001-CONSOLE-TERMINAL path=0/44.1
5. Use the LD command to verify the change:
io> LD 21
You will see:
LDEV:
21 DEVNAME:
ID: HP28639-60001-CONSOLE-TERMINAL RSIZE:
PATH: 0/44.1
6. Use the LP command to verify that the PMGR and LMGR are correct:
io> LP 0/44.1
See xref emscboot> and Table A-4 for the correct values.
7. Use the HOLD command to save the changes you have made:
io> HOLD
8. Use the EXIT command to exit the I/O Configurator:
io> EXIT
9. Use the KEEP command to keep the files from the configuration group to the
CONFIG.SYS group:
sysgen> KEEP CONFIG
10.Exit the SYSGEN program:
sysgen> EXIT
After the configuration is changed complete these additional steps:
1. Use NMMGR to set the modem type:
a. Open Config.
b. DTS.
c. Go To User Port.
d. Set the modem type as appropriate.
e. Save Data.
2. Validate DTS/LINK in NMMGR.
3. Cross-validate the configuration in SYSGEN by entering SYSGEN. Make sure there are
no new conflicts.
4. Create a new CSLT in SYSGEN. This saves the changes permanently.
Appendix A
OUTDEV:
0
MODE:
RSIZE:
128
DEVTYPE: DISC
MPETYPE:
4
MPESUBTYPE:
OUTDEV: 21
40
MPETYPE:16
MPE/iX Configuration and SYSGEN
Configuring the Remote Console
3 CLASS: DISC
MODE:
JAID
DEVTYPE: TERM
MPESUBTYPE: 0
SPOOL
A-7
Advertisement
Table of Contents
