HP 3000 99x Family Installation Manual page 152

Configuring the Remote Support Modem
Introduction
Introduction
99x/T-Class Systems permit remote support and a remote console. These functions require:
Access Port (AP) circuitry located on the Console/LAN card.
A properly configured remote support modem.
A cable for the remote support modem.
This appendix explains how to configure remote support modems.
The recommended remote support modem is an HP 50759A modem (Support Link). Other
modems can also be used.
The recommended cable is an HP 92219Q cable. The HP 40233A cable can also be used.
For V.22bis/V.25bis applications, the A1703-63006 modem cable is available (see "Modem
Cable Pin-out" later in this chapter).
Table C-1 and Table C-2 contain the latest recommendations from the
NOTE
Predictive Support team. These settings have been tested and will work for
Predictive Support.
The rest of this appendix contains reference information and
recommendations that were compiled earlier by another group. Some of the
recommendations later in the chapter are different than the Predictive
Support recommendations.
Appendix Organization:
This appendix is organized as follows:
Modem Settings for MPE/iX and HP-UX (Predictive Support)
Quick Reference.
General Guidelines.
Configuring Individual Modems
HP 50759A (Support Link) Modem
HP 50759B (Support Link) Modem
HP 37212B Modem
Hayes Smartmodem 2400
Black Box V.32 Plus (Version 2.01.01)
Multitech MT224EH7
Modem Cable Pin-out.
Console/LAN Card-Modem Line Behavior.
C-2 Appendix C