Release Notes for the Cisco Catalyst
Blade Switch 3020 for HP,
Cisco IOS Release 12.2(58)SE and Later
Revised April 23, 2011
Cisco IOS Release 12.2(58)SE images for all platforms were removed from Cisco.com because of a
Note
severe defect, CSCto62631. The solution for the defect is in Cisco IOS Release 12.2(58)SE1.
If you are using Enclosure Bay IP Addressing (EBIPA), you must upgrade the HP Onboard
Note
Administrator (OA) to firmware version 3.55 before you upgrade to Cisco IOS Release 12.2(58)SE or
later. If you do not upgrade the firmware, the HP OA will fail to assign an IP address to the Cisco Catalyst
Blade Switch 3020 module.
Cisco IOS Release 12.2(58)SE1 runs on the Cisco Catalyst Blade Switch 3020 for HP, referred to as the
switch.
If you wish to use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE through
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(50)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
These release notes include important information about Cisco IOS Release 12.2(58)SE1 and any
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
If you are installing a new switch, see the Cisco IOS release label on the switch packaging.
•
If your switch is on, use the show version privileged EXEC command. See the
•
Software Version and Feature Set" section on page
If you are upgrading to a new release, see the software upgrade filename for the software version.
•
See the
"Deciding Which Files to Use" section on page
For the complete list of Cisco Catalyst Blade Switch 3020 for HP documentation, see the
Documentation" section on page
You can download the switch software from this site (registered Cisco.com users with a login password):
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2011–2012 Cisco Systems, Inc. All rights reserved.
3.
21.
"Finding the
3.
"Related