Table of Contents
Advertisement
b. Remove front card cage cover if necessary.
c. Remove individual slot shields if necessary.
4. Install/verify PMB cards:
a. 990/992/890, 991/995/T500, and 996/T520 Systems. Processor cards in this
sequence: PMB slots 15, 14, 13, 12, 11, 10, 9, 8 (six processor cards maximum on the
890/T500 System and seven processor cards maximum on the T520 System).
b. 997/T600. Processor cards in this sequence: PMB slots 15, 14, 13, 11, 10, 9 (six
processor cards maximum).
NOTE
Each 997/T600 processor card is designed to accommodate two
processor daughterboards. The system is not designed to support two or
more processor cards that have only one daughterboard attached.
c. Bus converters (BC) and HP-HSC I/O Bus Converters (997/T600) in this sequence:
PMB slots 0, 1, 2, 3, 4, and 5 (six HP-HSC I/O Bus Converters maximum on
997/T600 Systems; four BC cards maximum on all other systems.) See "Terminology"
in Chapter 1.
d. Service processor (SP) card in the SP slot in rear PMB card cage.
e. Memory cards in this sequence: PMB slots 4, 6, 8, 9, 10, 11, 12, 13, 14, 7, 5, 3, 2, 1. If
one of these slots is occupied, go to the next slot in the sequence.
5. Install/verify power system:
997/T600 only:
a. Use the following table to verify that the power and PFC modules are properly
installed:
Table 3-1
3.3V 130A Power Supply Configuration
Processor Card Slot #
# of Processors
Power Modules Required
3.3V Power Module Slot #
NOTE
If the system was ordered with the "power resiliency" option, refer to
Appendix D, "Power Resiliency".
b. Slot P12 contains Miscellaneous Power Module (MPM).
c. Slot P14 contains +24V module.
d. Slots P5, P6, P7, and P13 contain +5V 325W (65A) power modules.
e. One PFC for systems with two or fewer processors. Two PFCs for systems with more
than two processors.
Chapter 3
15
14
1
2
3
4
5
1
2
P10
P9
13
11
10
6
7
8
9
3
P11
Installation
Summary
9
10
11
12
4
P1
3-3
Advertisement
Table of Contents
