Table of Contents
Advertisement
The Console
The console shipped with a T-Class or the 990CX, 991CX, 992CX, or 995CX is a 700/96
terminal.
The console shipped with a 990DX, 991DX, 992DX, or 995DX System is an OpenView
Console PC.
996 and 997 Systems can be ordered with either the 700/96 terminal or the OpenView
Console PC.
Procedures for installing these consoles follow.
The 700/96 Terminal as Console
On T-Class 990CX, 991CX, 992CX, 995CX, 996 and 997 Systems that have been ordered
with one, the 700/96 terminal should be connected to the console/LAN card as described in
the previous section ("Console/LAN Connections").
Configure the 700/96 terminal as shown:
Datacomm Configuration Parameters:
Baud Rate:
9600
Parity/Databits: None/8
Chk Parity:
NO
EnqAck:
YES
CS (CB)Xmit: NO
RecvPace:
Xon/Xoff
XmitPace:
Xon/Xoff
Configuration parameters that are not mentioned can be set to any value and do not affect
the operation of the Console/LAN card or the system.
OpenView Console
On 990DX, 991DX, 992DX, 995DX or 996 and 997 Systems that have been ordered with
one, the OpenView Console is a Vectra 386-based (or greater) OpenView Workstation
supplied with the necessary software to act as the system console. The OpenView Console
provides a windows-based, PC environment which allows system operators to monitor the
Corporate Business System via icons.
The PC software is preloaded on the internal hard disk at the factory prior to shipment.
Chapter 3
Installation
The Console
3-39
Advertisement
Table of Contents
