HP 3000 99x Family Installation Manual page 53

a. Verify connection of two flat ribbon cables from lower connectors (module 0) on BC
cards or HP-HSC I/O Bus Converters (997/T600) in PMB card cage to the BC card in
the HP-PB card cage.
b. Make/verify connections to the console/LAN card:
i. To console.
ii. To Service Processor (SP) card.
iii. To remote support modem.
iv. To LAN cable (ThinLAN or ThickLAN). Check/change position of jumper on
console/LAN card (INT for ThinLAN; EXT for ThickLAN).
8. Install PowerTrust UPS. If the system includes PowerTrust Uninterruptible Power
System (UPSs), install it according to the manual that accompanies it. Install the
system cabinet power cables.
9. Prepare console:
a. For T-Class, 990CX, 991CX, 992CX, 995CX, 996, and 997 Systems that have been
ordered with one: Connect the 700/96 console terminal to the LAN/console card.
Set/verify parameters on the console (Baud 9600; Parity/databits none/8; Chk parity
NO; EnqAck YES; CS (CB) Xmit NO; RecvPace Xon/Xoff; XmitPace Xon/Xoff).
b. For 990DX, 991DX, 992DX, 995DX, 996, and 997 Systems that have been ordered
with one: install the OpenView Console.
i. Connect OpenView PC to the LAN/console card with a direct connect cable.
ii. Connect OpenView PC into the LAN cabling.
iii. Power up the OpenView PC.
iv. Enter WIN at the C:\> prompt.
10.Install system disk and tape device.
a. Install system disk and tape device in an A1884A/A1897A expansion cabinet (refer
to 99x/T-Class Systems Expansion Cabinet Installation Guide (PN A1809-90006)).
b. Connect system disk to SPU:
i. For HP-FL system disks: Install the disk module containing the OS into slot 0 of
the disk array with the label "System Disk". Connect the system disk to the
HP-FL (PB-FL) card in double-high slot 12/13 of the internal HP-PB I/O card
cage. (Address 0/52.0).
ii. For SCSI and Fast/Wide SCSI system disks: Connect the system disk to the SCSI
card in slot 13 of the internal HP-PB I/O card cage. (Address 0/52.6.0).
c. Connect tape device to SPU:
i. For systems with HP-FL system disks:
1. For SCSI tape devices, connect the tape device to the SCSI card in slot 9 of the
internal HP-PB I/O card cage. (Address 0/36.0.0).
Chapter 3
Installation
Summary
3-5