Integrated Power Supply - HP HPE ProLiant ML350e Gen8 Maintenance And Service Manual

Remove the non-hot-plug drive.
13.
To replace the component, reverse the removal procedure.

Integrated power supply

To remove the component:
Power down the server (on page 24).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the front bezel (on page 25).
3.
Place the server on its side.
4.
Remove the access panel
5.
If installed, remove the PCI air baffle
6.
Remove the system air baffle
7.
Remove any installed full-length PCI cards
8.
Remove the fan modules and the fan blank
9.
Disconnect the power cables from the system board, drive cages, and optical drive.
10.
("Access panel" on page 26).
("PCI air baffle" on page 27).
("System air baffle" on page 28).
("Full-length expansion
("Fan modules and fan
board" on page 40).
blank" on page 30).
Removal and replacement procedures 34