Mitsubishi MIRAGE Service Manual page 129

Multi-information display
To reset
The "---" display can be reset while the igni-
tion switch or the operation mode is in OFF.
1. When you lightly press the multi-informa-
tion display switch a few times, the infor-
5
mation display switches to the service
reminder display.
2. Press and hold the multi-information dis-
play switch for about 1 second or more to
make the spanner mark start flashing. (If
there is no operation for about 10 seconds
with flashing, the display will revert to its
original indication.)
5-68 Features and controls
3. With this indicator flashing, if you lightly
press the multi-information meter switch,
the display switches from "---" to
"cLEAr". After that, the time until the
next periodic inspection is shown.
CAUTION
 The customer is responsible for making sure
that regular inspections and maintenance and
periodic inspections and maintenance are
performed.
Inspections and maintenance must be per-
formed to prevent accidents and malfunc-
tions.
NOTE
 The "---" display cannot be reset while the
ignition switch or the operation mode is in
ON.
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 When "---" is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next
periodic inspection is displayed.
 If you accidentally reset the display, consult
an authorized Mitsubishi Motors dealer for
assistance.
Changing the function settings
When the ignition switch or the operation
mode is in ON, the fuel consumption unit,
displayed in the multi-information display,
and the average fuel consumption reset mode
can be modified as desired.
CAUTION
 The driver should not operate the display
while the vehicle is in motion.
 When operating the system, stop the vehicle
in a safe area.
Changing the reset mode for aver-
age fuel consumption
You can change the mode condition for the
average fuel consumption display to "Auto
reset" or "Manual reset".
N00556800143
N00575500019