Turn Signal Lever; Headlight Flasher - Mitsubishi MIRAGE Service Manual

Turn signal lever

described above will not work. The lights (the
parking lights, tail lights and license plate
lights) will stay on and will not turn off auto-
matically.
Headlight reminder buzzer
5
[When using a key to start the engine]
If the driver's door is opened with the key in
the "OFF" or "ACC" position or removed
from the ignition switch while the lights are
on, the tone will sound to remind you to turn
off the lights.
[When using the F.A.S.T.-key to start the
engine]
If the driver's door is opened with the opera-
tion mode is put in OFF or ACC, or if the
operation mode is changed to OFF while the
lights are on, the tone will sound to remind
you to turn off the lights.
In either case, the lights will turn off automat-
ically and so will the tone. Or you can turn
the light switch to the "OFF" position to stop
the tone.
5-76 Features and controls
Dimmer (high/low beam
change)
To change the headlights from high beam to
low beam and vice versa, pull the turn signal
lever to (1). Switch the headlights to low
N00549800226
beam as a courtesy whenever there are
oncoming vehicles, or when there is traffic
moving ahead of you. An illuminated blue
light in the instrument cluster indicates when
the headlights are on high beam.

Headlight flasher

You can flash the high beams by pulling the
lever gently toward you (2). The lights will
go back to normal when you let go. While the
high beam is on, you will see a blue light on
the instrument panel.
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 You can flash the high beams by pulling the
lever toward you, even if the light switch is
N00549900142
off.
 If you turn the lights off with the head lights
set to high-beam illumination, the headlights
are automatically returned to their low-beam
setting when the light switch is next turned
to the " " position.
Turn signal lever
When changing lanes, or to making a gradual
turn, hold the lever in the "lane change" posi-
tion (1). It will return to the neutral position
when you let go. Use the full position (2)
when making a normal turn. The lever will
return to the neutral position when the turn is
complete. There may be times when the lever
does not return to the neutral position. This
usually happens when the steering wheel is
turned only slightly. You can easily return the
lever by hand.
Also, when you move the lever to (1) slightly
then release it, the turn signal lights and the
N00550000185 indicator light in the instrument cluster will
flash three times.
N00522600519