Power Settings On M450; Calibrate Kéo Power - Polar Electro M450 User Manual

POWER SETTINGS ON M450

Adjust the power settings to best suit your training needs. Edit the power settings in
files. Choose the profile you want to edit, and then choose
In the Bike power settings, you'll find:
Power view: Choose
l
Power, rolling
l
Set FTP value: Set your FTP value. The setting range is 60 to 600 watts.
l
Check power zone
l
CALIBRATE KÉO POWER
Calibrate Kéo Power before starting your session. The Polar LOOK Kéo Power system calibrates itself auto-
matically each time the transmitters wake up and M450 is found. The calibration takes a couple of seconds.
The temperature of your training environment affects calibration accuracy. If you're going to train out-
doors, for example, take your bike outdoors half an hour before doing the calibration. This way your bike's tem-
perature is about the same as that of your training environment.
To calibrate Kéo power:
1. Wake up the transmitters by rotating the cranks and choose pre-training mode on your M450 to start
the calibration.
2. Keep the bike upright and cranks in place until calibration is completed.
To ensure the calibration is done properly:
Do not put any weight on the pedals during calibration.
l
Do not interrupt the calibration.
l
When the calibration is complete a green LED will blink on the transmitters, and you can start your session.
Watts (W), Watts/kg (W/kg)
average: Set recording frequency. Choose 1, 3, 5,10, 15, 30 or 60 seconds.
limits: Check your power zone limits.
Bike power settings.
or % of FTP.
34
Settings > Sport pro-