Bidirectional Parallel Interface; Parallel Interface Communication Mode - Citizen CT-S280 Command Reference Manual

5.2 Bidirectional Parallel Interface

Overview
The interface of the printer is a Level-1 compatible device according to IEEE-P1284. It supports the communication modes
described in 5.2.1 below.

5.2.1 Parallel Interface Communication Mode

The parallel interface of the printer provides three communication modes as outlined below. When the printer is turned on or
reset, it defaults to Compatibility mode.
• Compatibility Mode
Data is transmitted from the host to the printer in units of one byte. Usually, this mode is used for data transmission. You may
switch to the other modes from Compatibility mode.
*Remarks: CT-P29x series cannot use this mode.
• Nibble Mode
Data is transmitted from the printer to the host in units of four bits. The data transmission from the printer uses a status signal
line. To send one byte of data in this mode, two sets of four-bit data are sent consecutively.
• Byte Mode
Data is transmitted from the printer to the host in units of one byte. Data transmission from the printer uses an 8-bit data
signal line. For Byte mode, the host must be capable of toggling the signal direction over the 8-bit data signal line.
Communication from the host to the printer is called Forward mode, while communication from the printer to the host is
called Reverse mode.
- 442 -