Example Of Using - Citizen CT-S280 Command Reference Manual

5.1.4 Example of Using PAGE MODE
The following explains specific uses of PAGE MODE.
When in PAGE MODE, the commands are typically sent from the host to the printer in the following sequence:
(1) An ESC L puts the printer in PAGE MODE.
(2) An ESC W specifies the print area.
(3) An ESC T specifies the print direction.
(4) Print data is sent.
(5) An FF instructs the printer to print the print data in a batch.
(6) After printing, the printer returns to STANDARD MODE.
< Example 1 >
100 PRINT #1，CHR$(&H1B);"L";
110 PRINT #1，CHR$(&H1B);"W";CHR$(0);CHR$(0);CHR$(0);CHR$(0);
120 PRINT #1，CHR$(200);CHR$(0);CHR$(144);CHR$(1);
130 PRINT #1，CHR$(&H1B);"T";CHR$(0);
140 PRINT #1，"Page mode lesson Test1"
150 PRINT #1，CHR$(&HC);
The program in Example 1 reserves a print area of 200  4 00 pitches extending from the start point (0, 0), and then prints the
text "Page Mode lesson Test 1" on the first line of the print area as shown in Figure 5-3
"Example 1: Results of Print".
Print Direction
(0,0) 200
Page mode lesson
Test1
400
Figure 5-3 Example 1: Results of Print
- 438 -
Paper
Print area