Gs G 2 M Nl Nh - Citizen CT-S280 Command Reference Manual

GS g 2 m nL nH

Support model
[Function] Sending maintenance counter
[Code] <1D>H<67>H<32>H<m><nL><nH>
[Range] m=0
20≤(nL+nH×256)≤198
nL=20, 21, 50, 70, 148, 149, 178, 198
nH=0
[Outline] [The specification which is common to the model]
• Send the maintenance counter value specified.
• nL, nH are used to set the maintenance counter number to (nL+nH×256).
• Configuration of data to be sent is shown below for the maintenance counter.
[Caution] [The specification which is common to the model]
• During sending block data (maintenance counter value), real-time status and ASB status shall not
be sent. Thus, during sending the data, printer status can not be notified.
• Counter value sent by this command is only a guideline value. Due to an error occurrence and power off
timing, figure data may have an error .
• To update the flash memory, write the flash memory if any change occurs in the
maintenance counter when the period where the printer is not in operation (printing,
paper feeding, drawer, or cutting) lasts about 10 seconds, 2 minutes, and 1 hour.
• If change occurs in each counter, data on RAM is updated correspondingly.
CT-S280 CT-S300
CT-S310
CT-S281
Counter Number
Hex. Decimal
14H 20
15H 21
32H 50
46H 70
94H 148
95H 149
B2H 178
C6H 198
Hex.
Header 5FH
Data 30H to 39H
NUL 00H
CT-S2000 CT-S4000
CT-S801/851 CT-S601/651
Counter [Unit]
Paper-feed line [line]
Head powering count [times]
Auto-cutter drive count [times]
Product operation time [hours]
Paper-feed line [line]
Head powering count [times]
Auto-cutter drive count [times]
Product operation time [hours]
Decimal
95
48 to 57
0
- 166 -
BD2-2220 PMU series
CT-P29x series CT-S310 II
Counter Type
Resettable
Resettable
Resettable
Resettable
Accumulated
Accumulated
Accumulated
Accumulated
Data Count
1 byte
1 to 10 bytes
1 byte