Suzuki DF 25 Service Manual page 98

5-10 FUEL SYSTEM
FLOAT
Install the float and the float pin.
NOTE :
After installing float, inspect for smooth movement of float.
CHECKING FLOAT HEIGHT
Measure the float height.
NOTE :
Make sure that float weight is not applied to needle valve.
09900-20101 : Vernier calipers
Float height H H H H H : 14.6 ± 1 mm
SETTING FLOAT HEIGHT
To correct specification, bend only the adjustment tab 1.
When adjusting tab, do not bend to the point that it
applies pressure to the needle and seat.
ADJUSTING ACCELERATION PUMP LEVER GAP
Adjust gap A between the acceleration pump lever and the
pump plunger rod by turning the adjust screw B.
Gap A
(at throttle valve fully closed)
NOTE :
• In normal use, adjustment of the acceleration pump lever is
unnecessary as it has been adjusted at factory.
0 mm