Suzuki DF 25 Service Manual page 175

7-58 POWER UNIT
CONROD CAP
Apply engine oil to crank pin and conrod bearing.
Install conrod cap (with bearing) to conrod with arrow mark on
cap toward flywheel side.
Reassemble each conrod cap its original position.
Apply engine oil to conrod bolts.
Tighten conrod cap nuts in two setps.
Conrod cap nut :
18 N . m ( 1.8 kg-m, 13.0 lb.-ft.)
1st step
Final step 35 N . m ( 3.5 kg-m, 25.5 lb.-ft.)
CRANKCASE TO CYLINDER
Clean mating surface of cylinder and crankcase.
Apply SUZUKI BOND to mating surface of crankcase as shown.
Apply bond to mating surface only.
Do not allow bond to contact surface of bearing.
99000-31140 : Suzuki Bond 1207B
Install four (4) dowel pins 1.
1 2 3 4 5 6
1 2 3 4 5 6
Apply Bond to marked line