Suzuki DF 25 Service Manual page 125

7-8 POWER UNIT
OIL PUMP SHAFT ENGAGEMENT
Install lock washer 2 and gasket 3 to oil pump stopper1, and
then screw (2-3 turns) the oil pump stopper 1 onto oil pan.
Do not screw oil pump shaft stopper fully before en-
gagingoil pump shaft with groove in camshaft. la leva.
Engage oil pump shaft with groove in camshaft by rotating screw
driver as shown.
While holding screw driver, tighten oil pump stopper 1 .
Oil pump stopper : 50 N . m (5.0 kg-m, 36.0 lb.-ft.)
After torquing stopper, bend two lock washer 2 tabs in the op-
posite
directions each other. (one upward and one down).
Tighten plug 4 with gasket 5 .
Oil pump stopper plug : 23 N . m (2.3 kg-m, 16.5 lb.-ft.)
FLYWHEEL
Install battery charge & power source coil. (See page 3-18)
Install CKP sensors. (See page 3-18)
Install flywheel and tighten flywheel bolt to specified torque. (See
page 3-18)
Apply engine oil lightly to flywheel bolt before installing.
09930-48720 : Flywheel holder
Flywheel bolt : 190 N . m (19.0 kg-m, 137.5 lb.-ft.)
Camshaft
Groove
Screw driver
Oil pump
shaft