Information On Media When Using Optional Cutter; Cutting Of Labels; Cutting Media With Perforation; Cutter Replacement - SATO GZ4e Series Operator's Manual

8.5 INFORMATION ON MEDIA WHEN USING OPTIONAL CUTTER

8.5.1 Cutting of Labels

The correct cutting position is at the label gap. Cutting onto
the label must be avoided because the label adhesive that
accumulates on the blade will affect cutter sharpness.

8.5.2 Cutting Media with Perforation

As for media with perforation, cutting on or in front of the
perforated lines is prohibited. Cutting in those locations
could cause the media to jam and the printer to malfunction.
The perforated line +1 mm (+0.04") is the cut prohibited
zone.

8.5.3 Cutter Replacement

Over time, the cutter loses its cutting ability and begins to show
signs of wear.
Replace the cutter unit when the blade becomes blunt and cut
edges are rough. (Please contact an authorized SATO
Representative for replacement.)
GZ4e Series Operator Manual
Cut Position
Cut Position
Cut prohibited zone
(1 mm, 0.04")
Section 8: Appendix
Label
Backing paper
Label
Perforated line
1 2 3 — 4 5 6
1 2 3 —456
Page 8-7