Installing The Media (Optional Cutter Model); Installing The Media (Optional Dispenser Model With Liner Discharge Outlet) - SATO CL4NX Operator's Manual

3 Installing Carbon Ribbon and Media
3.5.3

Installing the Media (Optional Cutter Model)

Refer to the procedures in
to install the media.
Media
For cutter model, pull the tab
the direction as shown, then open up the cutter before
passing the media through the cutter.
CAUTION
• Be careful not to touch the cutter blade with your fingers.
3.5.4 Installing the Media (Optional Dispenser Model with Liner
Discharge Outlet)
This section describes the procedures to dispense the
label and eject the liner out of the printer.
1
Refer to the steps 1 to 6 of
Installing the Media Roll
media.
2
Press the tab  at the front of the printer to
open the dispenser unit .
40
CL4NX Operator Manual
Section 3.5.1 Installing the Media Roll
of the cutter unit to

Section 3.5.1
to install the
or
Section 3.5.2 Installing the Fan-fold
2
2
1
1
1