Operating Modes - SATO GZ4e Series Operator's Manual

3.4 OPERATING MODES

This chapter provides an overview of the various configuration modes of the operation menu. All the
configuration activities are performed via the use of the operator panel located on the printer's face. However,
many settings may also be controlled via external software commands. In the case of conflict between
external software commands and internal software commands (control panel settings) the printer will always
use the last valid setting (the default is software commands).
If you load a label job that includes software settings and then enter a new setting via the operator panel, the
manually set values will be used by the printer. If you set the values manually and then download a job with
software settings, the software settings will be used.
There are several modes of operation. To enter the desired mode, the button sequence combination listed
below must be performed.
POWER: OFF
GZ4e Series Operator Manual
Normal mode
Power on
ONLINE
Advanced mode
LINE + Power on
Emulation mode
EMULATION MODE
User Test Print mode
FEED + Power on
TEST PRINT MODE
Download mode
DSW2-6 ON +
Power on
FLASH DOWNLOAD
Default setting mode
LINE + FEED +
Power on
DEFAULT SETTING
HEX Dump
DSW2-4 ON +
Power on
ONLINE
Non Standard mode
DSW2-7 ON + LINE +
FEED + Power on
ALT. PROTOCOL
DEFAULT COMPLETE
Protocol Download mode
DSW2-7 ON +
LINE + Power on
USER DOWNLOAD
Figure 3-1, Operating Mode
[S]
QTY: 000000
FEED
ADVANCED MODE
FEED
FEED
CONFIGURATION
READY
YES NO
[S]
QTY: 000000
PRESS LINE KEY
Section 3: Configuration and Operation
Service mode
SERVICE MODE
FEED
Counters mode
COUNTERS MODE
Page 3-11